DRMFG光纖切割刀刀片：
1、DR精細鎢鋼，HRA≥92.5
2、刀片可旋轉16個轉位
3、每刀位平均切割壽命約3000 次
4、切割角度＜0.5 度
5、400倍顯微鏡下全檢尺寸
6、質量穩定，完全替代進口
7. 十年製造，服務全球
適用於機型：騰倉 日新 吉隆 DVP等 CT-30,CT -30A，CT-30B，CT-32，CT-38，CT-20,CT-20-11,CT-20-12,和HTC-20 KL-260 280 300 KL-21B DVP-730
DVP-105等
光纖切割熔接不良原因有很多，常見因素有：
1.刀刃或光纖上粘有異物雜質；
2.切割角度不垂直，重新安裝調試；
3.刀刃位置太遠，切割深度不夠，需重新安裝。
4.裸纖塗覆層未剝離幹淨
DRMFG fiber cutting knife blade:
1. DR fine tungsten steel, HRA ≥ 92.5
2. The blade can rotate 12 to the transfer
3. The
average cutting life of each knife is about 3,000 times
4. Cut angle <0.5 degrees
5, 400 times the size of the full
inspection of the microscope of the microscope
6. Stable quality, completely replacing imports
7. Made in ten years to
serve the world
Product Features:
Cutting angle stable
Extension of cutting life
Easy to replace blade
Low temperature cutting is normal
There are many failure reasons for optical fiber cutting and melting.
The common factors are:
1. An impurities sticky on the blade or fiber;
2. The cutting angle is not vertical, reinstall and debug;
3. The blade is too far away, and the depth of cutting is insufficient. You need to reinstall it.
4. Naked fiber coating layer is not peeled off cleanly.
welcome必发集团，定製十年，服務全球，品質穩定，替代進口！
welcome必发集团，定製十年，服務全球，品質穩定，替代進口！
掃一掃關注
公眾號
DRMFG